The bass should be loud enough that the low end is big and powerful, but not so loud that it overpowers the kick drum. Remember to check your reference mixes often to make sure you’re staying on course. Once you have the bass level where you want it, don’t be afraid to adjust some of the other faders as well.
What dB should bass be at?
79-85 dB is a good level to monitor at when making adjustments to bass. More than 85 dB and the bass will feel louder, so you will bring the low end down in the mix which leads to a bass light mix. Quieter than 79dB and the low end will feel too soft which will lead to you boosting the bass too much.
Should bass be louder than vocals?
To recap: In general, your vocal level should be lower than the drums, but louder than the instrumentation. Vocal mixing to a professional mix engineer’s standard, however, requires more nuanced decisions than that, to get your vocals to sit right.
How loud should bass be compared to drums?
So, in these genres, drums, especially kick and snare, should be just loud enough to cut through at any monitoring levels in any sound system.
How loud should drums be in a mix?
| Drums Bus | -12 dB LUFS | 0.6 dbTP |
|---|---|---|
| Bass | – 17 dB LUFS | -5.8 dBTP |
How loud should the kick and bass be in a mix?
You could start with the kick at -10dB on the VU meter and aim to get the VU touching -7dB when both the kick and bass are combined to achieve the same result. This technique will work as long as the VU meter shows a 3dB increase after the bass has been soloed alongside the kick.
What is dB in bass?
Bass (dB) The amount of gain (amplification above 0 dB or attenuation below 0 dB) to bass (low) frequencies. Set this to a positive amount to boost the bass, or to a negative amount to reduce the bass.
Can you measure bass noise?
Use audio-spectrum-analyzer software that runs on your computer or smartphone. Set up a test microphone (or hold your smartphone) in your listening position. Play the appropriate test tone and you’ll see the level of each frequency of sound onscreen. The idea is to get each bass frequency at roughly the same level.
How loud should my kick be?
Next, bring the kick fader up until it sounds almost as loud as the snare. It should be loud enough that the low frequencies are rich and powerful, but not so loud that it masks the bottom-end of the snare drum.
How loud should my song be?
-14 LUFS is the best mastering level for streaming, as it will fit the loudness targets for the majority of streaming sources. I would also aim for -0.2 db PEAK level. However, it’s still a good idea to go a tad louder (-7 to -10 LUFS) so that your music will still sound loud on other mediums and platforms.
What level should I gain stage?
So maintaining the same concept of optimal gain staging that you use during recording is your best bet: –18dBFS is a good average level to aim for. Keeping it conservative will help you maintain proper gain structure throughout your mix.
What dB should you mix at?
what volume should you mix at? To hear the most accurate representation of your music, you should mix at 85db to 90db while EQing and critical listening. The rest of the time you should mix at a volume level that allows for a conversation without raising your voice.
What Hz is bass?
The bass range is a range that many people are passionate about. The bass range area lies around 60 – 250 Hz.
Should kick be lower than bass?
Traditionally, the kick drum bangs out the lower portion of the low-end while the bass hums along higher. What is this? But in recent pop music, largely in techno and drum & bass electronic music, the bass will be the lower of the two. Both options are legit and you’ll need to make this choice first.
How do I EQ my bass?
A General Starting Point – When EQing bass with a bass roll off, I recommend setting the main frequency around 50 Hz with a steep enough Q that you gradually but quickly reduce the volumes the closer you get to 20 Hz. This will allow some sub-bass but ensure you aren’t rattling speakers.
Where does bass sit in a mix?
Whether the bass guitar has the priority or not is going to vary depending on the genre. If it’s something like hip-hop or electronic music, then the kick is probably going to have priority over the bass. The kick drum will take up a lot more of the low end, and the bass guitar will sit a little higher in the mix.
At what frequency is bass punchy?
And those who find that sending bass to both the sub and the mains gives that “punchy bass” between 60 and 80HZ that’s missing otherwise!
Is higher or lower dB better?
Decibel Level
Sounds at or below 70 dBA are generally considered safe. Any sound at or above 85 dBA is more likely to damage your hearing over time. Researchers have found that people who are exposed over long periods of time to noise levels at 85 dBA or higher are at a much greater risk for hearing loss.
What is considered a loud subwoofer?
If you want a subwoofer that is going to play your music as loud as possible, then go with something that has a power rating of 300 watts or higher.
How many dB is too loud?
Sound is measured in units called decibels. Sounds at or below 70 A-weighted decibels (dBA) are generally safe. Long or repeated exposure to sounds at or above 85 dBA can cause hearing loss.
What is 90 decibels sound like?
90 decibels is a high noise level, equivalent to the noise generated by a leaf blower or the sound level of a concert.
What does 120 decibels sound like?
120 – 140 decibels: Such as, a rock concert, auto racing, or a hammer pounding a nail. 125 – 155 decibels: Like, firecrackers or fireworks, or a jet engine. 170 – 190 decibels: For example, a shot gun blast or a rocket lift off.